• Contact your utility supplier to locate and mark underground lines.
• Careful planning and measuring of your fence project is essential,
as moving posts after the concrete sets is extremely difficult.
Distance Between Posts (inside to inside)
• For a single gate, measure the actual width of the gate and add
2". (For instance: A 48" wide gate would have an inside to inside
post distance of 50")
• For double gates, measure the actual total width of both gates
and add 3". (For instance: Two 60" wide gate leafs would have
an inside to inside post distance of 123")
Digging Post Holes
• (DETAIL D) Dig post holes 12" to 16" in diameter and 36" to 42"
deep (depending on local ordinance or expected frost depth in
Setting and Installing Posts and Panels
• Insert a post into the hole. Level and adjust the height as needed
using gravel. (DETAIL D)
• Fill holes with concrete, mix thoroughly and follow directions on the
bag. Check to make sure posts are still level. Let concrete properly
cure according to manufacturer's recommendations before hang-
ing gate(s). (DETAIL D)
Hanging the Gate(s)
• Lay the gate on a flat surface or ground. Add hinges to gate frame
(as per diagram) 6" from top and 6" from bottom (using screws
provided with hinges). (DETAIL B) IMPORTANT NOTE: Double check
before adding hinges that desired swing direction and latch posi-
tion is correct.
• Place gate against hinge post, adjust height accordingly, attach
hinges to post using provided screws. (DETAIL B)
• Adjust gate hinges (if necessary) to achieve 1" spacing between
latch post and gate and that the gate is square overall.
• Add latch to gate with screws provided. IMPORTANT NOTE: Before
you add screw, make sure the latch is in correct position to acco-
modate for the swing of the gate. (DETAIL A)
• Add a gate stop to the bottom of the gate to protect from damage
through slamming. (DETAIL C)
• Install a post cap on each post using PVC glue or an exterior
• For walk gates, it is strongly recommended to use a drop rod.
For double drive gates, use a drop rod on each leaf of the gate.
• Use Heavy Duty Gate Posts 5" x 5" (VH55_ _ _) or Majestic Entryway
Gate Posts 8" x 8" (V88_ _ _)
www.illusionsfence.com
The diagrams and instructions shown are for illustration purposes only and are not meant
to replace a licensed professional. Any construction or use of the product must be in ac-
cordance with all local zoning and building codes. The consumer assumes all risks and li-
ability associated with the construction or use of this product. The consumer or contractor
should take all necessary steps to ensure the safety or everyone involved in the project,
including, but not limited to, wearing the appropriate safety equipment. EXCEPT AS CON-
TAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT PROVIDE ANY
OTHER WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY
DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
Illusions Gate Instructions 0912. Illusions Fence ©2012 All rights reserved.
Made in the USA.
Hinges mounted 6"
from edge of frame
to hinge on both top
and bottom